From a tape sample
to a construction sourcing brief
PAC KING at Canton Fair 2026 Phase 1: a closer look at booth 9.1D30 and the practical questions that help building-material buyers move from a first introduction to a useful sample evaluation.
- Event
- Autumn Canton Fair 2026
- Phase
- Phase 1 · October 2026
- Booth
- 9.1D30
- Exhibitor
- PAC KING / BCD TECH

Start with the job,
not just the roll
At Phase 1 of the autumn Canton Fair, PAC KING welcomed visitors at booth 9.1D30. These photographs record introductions, handshakes and sample displays at the stand.
For a building-material distributor or project buyer, the next step is to connect those samples with a specific task. A roll’s colour or appearance alone cannot tell you whether it suits a painted frame, a temporary floor-protection job or a sealing detail.
That is the approach we bring to construction sourcing: identify where the material will be used, then narrow the options and arrange an appropriate evaluation.
Explore our construction tape application guide →Three useful starting points for a sample discussion
A trade-fair meeting does not replace application testing. It can, however, help define what the test needs to answer. For construction enquiries, these are useful ways to organise the follow-up.
Protect the finished surface
For temporary masking and protection, tell us the surface finish, the expected time before removal and whether the work is indoors or exposed to weather. Evaluate removal on the actual surface before wider use.
Masking & surface protection →Define the joint or detail
For sealing enquiries, provide the substrates, joint geometry and exposure conditions. A photograph or drawing of the detail is more useful than selecting solely by tape width or backing colour.
Waterproofing & sealing →Match the finishing process
For drywall and repair products, identify the board, joint or corner and the finishing system. Sample selection should reflect the intended installation method rather than the shelf appearance alone.
Drywall & repair →At the Phase 1 stand
People, samples and face-to-face introductions at booth 9.1D30. Each photograph is kept in its original proportions.






Turn your visit into a clear next step
If you met us at the fair, you do not need to remember every product name. Send a booth photograph or describe the sample you saw, together with the following information.
- The task: what needs masking, protecting, joining, repairing or sealing?
- The surface: substrate, coating or finish, with a close-up photograph if possible.
- The conditions: installation environment, exposure and expected removal or service requirements.
- The buying plan: sample quantity, preferred roll size, target market and intended order volume.
Following up after Phase 1
Where was PAC KING’s Phase 1 booth?
Our confirmed booth for the autumn Canton Fair 2026 Phase 1 was 9.1D30.
Can I request a sample based on a photograph?
Yes. Share the photograph and explain the intended construction task. We will first confirm the product identity and the requirements before recommending a sample.
Does the exhibition sample confirm suitability for my project?
No. Suitability depends on the specific product and installation conditions. Review the relevant product information and evaluate a sample on the intended surface before committing to a bulk order.
